![]() Time for bed now, so I threw the spool in a dryer and will try again tomorrow. I checked the extruder motor gear and the set screw is tight. From there click Prusa FFF Under MK3 Family put a checkmark on the. You can use pliers to get a better grip in otherwise hard-to-reach places. When you open PrusaSlicer for the first time the Configuration Wizard should come up. When the print finishes, depending on the model geometry and material used, the support structure is often easily removable with bare hands. I could not find a tension or settings that did not result in under-extrusion followed by gaps in the printed lines, at best. Supports can be turned on from the right panel or in the Print settings - Support material - Generate support material. I loosened the idler spring almost all the way, but the idler gear wasn't spinning so I had to tighten it back up. Also did a cold pull to ensure the nozzle was fully clear after printing with the PLA. I wonder which of the two to set, which of the two takes precedence over the other. Just Flexing Ender 3 (V2/Pro) & TPU: How to Print Flexible Filaments by Karen Ditsch Updated Flexible filaments are fun to 3D print with but challenging to get right. Retraction the other is in Filament settings/ Filament Overrides / Retraction. I tried adjusting speed down to 15 mm/s, and tried lowering and raising nozzle temp. (emanuele) Active Member Prusa Slicer Retraction Settings In PrusaSlicer there are two configurations for retraction, one is in Printer Settings / Extruder No. Today I tried printing Overture TPU using a textured sheet, 20 mm/s, 230C nozzle and 50C bed. Note that the print and filament settings presets provide by Prusa are specific to each equipment manufacturer. When a printer is selected, a configuration bundle is imported which contains print, filament, and printer presets for that printer. Overall I am happy with the printer calibration and print quality when using PLA. Prusa provides a number of system presets for each supported printer. ![]() Yesterday I finished building an MK3S+ kit and printed a few things using PLA with only minor issues. I spent tonight trying to print Overture TPU and can't get a good print yet. RE: Recommendations for settings for Overture TPU using M3S+ were you able to successfully print with Overture TPU? If so, did you follow the advice of and Any other tips you can add?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |